久久久久久久久久网站-久久久久久久久久免费视频-久久久久久久久久免费-久久久久久久久久久影院-一级毛片一级毛片-一级毛片一级黄片

In the case of a lathe, axis names (coordinate words) and directions are defined as follows.
The axis at right angles to the spindle
　 Axis name: X axis
The axis parallel to the spindle
　 Axis name: Z axis
Coordinate axes and polarities
Since coordinates based on the right hand rule are used with a lathe, in the above figure, the positive direction
of the Y axis which is at right angles to the X-Z plane is downward.
Note that a circular on the X-Z plane is expressed as clockwise or counterclockwise as seen from the forward
direction of the Y axis.
(Refer to the section on circular interpolation.)
(a) Spindle stock
(b) Tailstock
(c) Tool
(d) Turret
+X
+Y
+Z
(a)
(b)
(c)
(d)
PLC FX2N-16MT-001
PLC FX2N-64MR-ES/UL
模擬量輸入模塊 AJ35T-M12B-R
多路轉換模塊 A60MXR
PLC FX2N-48MR-UA1/UL
伺服放大器 MR-J2S-70B
多路轉換模塊 A60MXTN
PLC FX2N-32MT-ESS/UL
PLC FX2N-32MR-001
CC-Link接口單元 MR-J2S-T01
電磁制動器用電纜 MR-BKS1CBL5M-A1-L
伺服放大器 MR-J2S-350B4
可編程控制器 FX1N-60MT-001
PLC FX3U-80MT/DSS
模擬量輸入模塊 AJ35T-M16B-R
可編程控制器 FX1N-14MR-001
視頻/RGB輸入單元 GT16M-V4R1
PLC FX3U-48MR/DS
存儲卡 FX-EEPROM-16
伺服驅動器 MR-J2S-37KA4
PLC FX2NC-16MR-T-DS
PLC FX3U-64MT/ESS
伺服電機 HC-MFS43B
MODBUS模塊 QJ71MT91
PLC FX2NC-96MT-D/UL
控制器放大器總線電纜 MR-J2HBUS5M-A
GT16觸摸屏 GT1695M-XTBD
伺服馬達 HA-LFS15K1M
編碼器用電纜 MR-EKCBL2M-H
串行多點連接單元 GT01-RS4-M