久久久久久久久久网站-久久久久久久久久免费视频-久久久久久久久久免费-久久久久久久久久久影院-一级毛片一级毛片-一级毛片一级黄片

[DESIGN PRECAUTIONS]
DANGER
z Do not write data to the "System Area" in the intelligent function module's
buffer memory. Also, do not turn the output for signals for "Use Prohibited"
signals among the output signals from the PLC CPU to the intelligent
function module (ON).If data are written to the "System Area" or output in
response to "Use Prohibited" signals, there is danger that the PLC system
will malfunction.

CAUTION
z Do not bunch the control wires or communication cables with the main circuit
or power wires, or install them close to each other. They should be installed
100mm (3.94 in.) or more from each other. Not doing so could result in noise
that may cause malfunction.
z If a BASIC program is registered in the EEP-ROM in the module, do not
perform a power OFF or PLC CPU reset operation at the station where the
module is installed during registration. If a power OFF or PLC CPU reset
operation is performed at the station where the module is installed during
registration, the data contents in the EEP-ROM will be indefinite and it will be
necessary to reset the setting values, etc. in the buffer memory and register
them again in the EEP-ROM. It could also cause the module to break down
or malfunction.
[INSTALLATION PRECAUTIONS]
CAUTION
z Use the PLC in an environment that meets the general specifications
轉換適配器 FX2NC-CNV-IF
模塊 AJ35PTC-CNV-GI
模擬量輸出模塊 A68DAI-S1
中繼模塊 AJ65BT-RPI-10B
模塊 AJ35PP-CNV-GI
電流輸入模擬量模塊 Q68ADI
中斷模塊 QI60
仿真單元 A6SIM-X64Y64
模塊 A1SJ71ID1-R4
中斷輸入模塊 QI60
適配器 Q6DIN1A
外部輸入/輸出單元 GT15-DIOR
中斷模塊 AI61
模塊 AJ35PTC-CNV-GI
ID接口模塊 QD35ID2
AS-I主站模塊 FX2N-32ASI-M
模塊 A1SD32ID2
模塊 AD32ID2
模擬量輸出模塊 Q68DAV，Q68DAI
中繼模塊 AJ65BT-RPI-10A
模擬量模塊 AJ65BT-64DAI
模塊 AJ35PTC-CNV-SI
中斷模塊 AI61-S1
模塊 A1SJ71ID2-R4
模塊 AD32ID1
外部輸入/輸出單元 GT15-DIO
模擬量模塊 AJ65VBTCU-68ADIN
模塊 A1SD35ID1
RS-232C通訊用模塊 FX2N-232IF
模塊 AJ35PP-CNV-GI