久久久久久久久久网站-久久久久久久久久免费视频-久久久久久久久久免费-久久久久久久久久久影院-一级毛片一级毛片-一级毛片一级黄片

Warranty
Mitsubishi will not be held liable for damage caused by factors found not to
cause of Mitsubishi; machine damage or lost profits caused by faults in the Mit
products; damage, secondary damage, accident compensation caused by
factors unpredictable by Mitsubishi; damages to products other than Mit
products; and to other duties.
For safe use
• This product has been manufactured as a general-purpose part for general
industries, and has not been designed or manufactured to be incorporated in
device or system used in purposes related to human life.
• Before using the product for special purposes such as nuclear power, electric
aerospace, medicine or passenger movement vehicles, consult with Mitsubis
• This product has been manufactured under strict quality control. However wh
installing the product where major accidents or losses could occur if the prod
This manual confers no industrial property rights or any rights of any other kin
does it confer any patent licenses. Mitsubishi Electric Corporation cannot b
responsible for any problems involving industrial property rights which may oc
a result of using the contents noted in this manual.
ment pressurized above the
ound the altitude of 0 m. If the
il.
n outside the control panel as
ng temperature, the ambient
y to which the equipment is
ation
shall not be considered.
shall not be considered.
esent
Number of times of
sweep
mplitude
10 times in each of
X, Y and Z directions
(for 80 min)
mm
−
sent
mplitude
mm
−
Y and Z directions
nt.
5.2 Output specifications
5.3 Performance specifications
Item Specification
Output method
Transistor output
(using module power supply in common) (sink)
Number of outputs 2 points
Isolation method Isolation with photocoupler
Rated load voltage 24V DC
Operating load voltage
range
Same as module power supply
Max. load current 0.1A/point 0.2 A/1 common
Max. inrush current 0.4A/10 ms
Leakage current at OFF 0.1mA or less/30V DC
Max. voltage drop at ON 1V or less (max.)/0.1A
Response
time
OFF→ON 1.0ms or less
ON→OFF 1.0ms or less
Surge suppression Zener diode
Common wiring method 2 point/1 common (1 point)
Internal protection for
outputs
Internal protection circuit none
Please connect the fuse in the connected load
outside.
Item Specification
Module
power
supply
Vol tage
20.4 to 28.8V DC (24V DC -15% to +20%)
Ripple ratio: Within 5%
Current
consumption
40mA (when all points are ON)
Initial current 70mA
Max. allowable
momentary power
failure period
PS1:1ms
Number of stations
occupied
4-, 8- or 16-point mode: 1 station
Noise durability
500Vp-p
Noise width: 1µs Cycle: 25 to 60 Hz
(by noise simulator)
Withstand voltage 500V AC for 1 min
Isolation resistance
10 MΩ or more between primary area (external
DC terminal) and secondary area (internal circuit)
by 500V DC megger
Protection class IP2X
I/O part connection method Connection with cable
6. Outside Dimensions
24G Y0 Y1 +24V
Unit: mm(inches)
20(0.79")
65(2.56") 500(19.69")
12(0.48")
500(19.69")
接頭套件 MR-ECN1
伺服電機電源用電纜 MR-PWS2CBL03M-A2-L
DC 輸入/晶體管輸出模塊 AJ65VBTCE32-32DT
運動CPU單元 A73CPUP21-S1
RS-485適配器 FX2NC-485ADP
小型CPU擴展電纜 GT15-A1SC07B
QCPU（Q模式）用總線連接電纜 GT15-QC06B
RS-422電纜 GT01-C100R4-25P
編碼器接頭 MR-J3ENSCBL20M-L
伺服電機 HC-MFS73B
伺服電機 HC-SFS102
SSCNET Ⅲ 接頭套件 MR-J3BCN1
GOT到GOT連接電纜 GT15-C50BS
模塊 AJ35PP-CNV-GI
變頻器 FR-F740-15K-CHT
伺服電機 HC-SFS702B
性能型QCPU Q02CPU
RS-422電纜 FX-422CAB0
伺服電機 HC-KFS73K
輸出模塊 AY13C
溫度控制模塊 FX2N-2LC
CPU單元 A2USHCPU-S1
編碼器電纜 MR-ENCBL20M-H
CPU單元 Q2ACPU
擴展電纜 A1SC60B
伺服電機電源用電纜 MR-PWS1CBL5M-A2-H
制動器接頭 MR-BKCN
編碼器接頭 MR-J3ENSCBL30M-L
伺服電機 HC-MFS43B
連接電纜 FX-232CAB-2